Indoor Air Quality and Mold Testing in Prince George's County, MD
From Hyattsville, Greenbelt and Laurel to Bowie, Lanham and Fort Washington, we test the air and the building in Prince George's County homes, and put the results in a written report you can act on. Our Silver Spring office is a short drive across the county line.
We find the moisture first, then test the air.
Most of our Prince George's County calls are about mold: a musty basement, a stain that keeps coming back, or a leak that was never fully dried. Air results only make sense next to what is happening in the building, so we look at both.
- Moisture mapping. Pin and pinless meters and an infrared camera along the walls, floors and ceilings, so we know where the water is before anything is opened.
- Air sampling. Spore trap samples in the rooms of concern, compared to an outdoor control taken the same day.
- HVAC check. A borescope look inside the air handler and ducts, because a damp system can carry a problem to every room.
When the question is the air itself.
Some calls are not about mold at all: a chemical smell after a renovation, headaches that ease outside, or soot after a furnace puff-back. We pick the test after the walkthrough.
More than 10 Prince George's County homes.
Most were mold and moisture inspections, with a few asbestos surveys before renovation, spread across the county:
Prince George's County answers.
Do you cover my part of the county?
Yes. Prince George's County is inside our residential service area, from Laurel and Bowie down to Fort Washington and Oxon Hill. Mileage only applies on longer drives, and we tell you on the call.
My basement smells musty but I cannot see anything. What do you do?
We take moisture readings along the base of the walls and the floor, scan with infrared and sample the air against an outdoor control. The report shows where the water is and whether the air is affected.
How soon will I have results?
For mold, the report usually comes within two business days of receiving the lab results, and a 24-hour rush is available. VOC canisters take longer at the laboratory, and we give you that timeline before we sample.
Can you test for radon in the same visit?
Yes. Our NRPP-certified measurement places a continuous monitor in the lowest livable level for at least 48 hours, and it can go in during a mold or air quality visit.
Do you do the mold removal too?
No. We only inspect and test, so our findings are not tied to a repair estimate. If work is needed, the report tells your contractor exactly what and where.
One call for Prince George's County.
Weekdays 8 to 5. Tell us the town and what you are noticing, and we will quote it on the call. Also serving Montgomery County, Washington DC and Northern Virginia.